Set Up Custom Borders
Set Up Custom Borders
set-up-custom-borders-2025-ep39
Set Up Custom Borders
October 2025 · 24:37
Sets up a decorative border on a quilt: placing the corner design and the border design as a matched set, defining the layout box with points just inside the border, and layering the border piece on top of the corners. Notes that auto-scale and auto-fill aren't available for this kind of layout, so scaling is done manually, and shows leaving a small margin of wiggle room before stitching out.
Butler features
More on Borders
- Finish Vertical Borders · 16:55
Finishes the side borders on the same quilt. Brings back the saved design from the Saved tag, uses Rotate (45 and 45) to stand it upright, then sets Point to Point points along chalk marks. Covers the single-stitch and needle-cycle prompts at the start before stitching out the clamshells.
- Fill Vertical Borders · 17:10
Fills the vertical side borders of a long quilt using Point to Point with a repeat. Sets the layout at the corners where the borders meet, uses Rotate (45 degrees twice) to stand the saved design upright, and works area by area down the sides. Useful when the quilt is longer than the frame width and can't be turned.
- Quilting Journey, Part 2 · 15:29
Continues the whole-cloth quilt. Turns on the proportion lock before using Auto Scale so a design changes proportionally to fit the border width, adds a small margin under Settings, Parameters, and then stitches. Reminds you to engage the needle before pressing Go, otherwise the robot only traces the design.
- Borders, Part 3 · 9:34
Third and final border method, using regular layout boxes with edge-to-edge designs. Creates a pattern box along the border, repeats the design, rotates it in 45-degree steps to run the right direction, and uses Auto Scale to fit it. Closes by noting there is no single right way to fill a border, so use the method you are comfortable with.


